Search results
Results from the WOW.Com Content Network
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
Depending on the roof covering material, either horizontal laths, battens, or purlins are fixed to the rafters; or boards, plywood, or oriented strand board form the roof deck (also called the sheeting or sheathing) to support the roof covering. Heavier under purlins or purlin plates are used to support longer rafter spans.
A simple timber frame made of straight vertical and horizontal pieces with a common rafter roof without purlins. The term box frame is not well defined and has been used for any kind of framing (with the usual exception of cruck framing). The distinction presented here is that the roof load is carried by the exterior walls.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
For longer span rafters, building materials manufacturers have created laminated veneer lumber (LVL) rafters that can be 2–5 times longer than typical wood rafter. In the US, most wood rafters have maximum length of 20 feet (6.1 m). [5] If a longer rafter is needed, LVL is an alternative.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]