Search results
Results from the WOW.Com Content Network
Although a serial link may seem inferior to a parallel one, since it can transmit less data per clock cycle, it is often the case that serial links can be clocked considerably faster than parallel links in order to achieve a higher data rate. Several factors allow serial to be clocked at a higher rate: Clock skew between different channels is ...
However, parallel lines have lower latency than serial lines, this makes parallel lines is still used on memory bus like DDR SDRAM. Cable length or link length: Crosstalk creates interference between the parallel lines, and the effect worsens with the length of the communication link. This places an upper limit on the length of a parallel data ...
The 9-pin DE-9 connector has been used by most IBM-compatible PCs since the Serial/Parallel Adapter option for the PC-AT, where the 9-pin connector allowed a serial and parallel port to fit on the same card. [4] This connector has been standardized for RS-232 as TIA-574.
In computing, a parallel port is a type of interface found on early computers (personal and otherwise) for connecting peripherals. The name refers to the way the data is sent; parallel ports send multiple bits of data at once (parallel communication), as opposed to serial communication, in which bits are sent one at a
By convention, bus and network data rates are denoted either in bits per second (bit/s) or bytes per second (B/s). In general, parallel interfaces are quoted in B/s and serial in bit/s. The more commonly used is shown below in bold type.
Buses can be parallel buses, which carry data words in parallel on multiple wires, or serial buses, which carry data in bit-serial form. The addition of extra power and control connections, differential drivers , and data connections in each direction usually means that most serial buses have more conductors than the minimum of one used in 1 ...
These blocks convert data between serial data and parallel interfaces in each direction. The term "SerDes" generically refers to interfaces used in various technologies and applications. The primary use of a SerDes is to provide data transmission over a single line or a differential pair in order to minimize the number of I/O pins and ...
All digital computers built before 1951, and most of the early massive parallel processing machines used a bit-serial architecture—they were serial computers. Bit-serial architectures were developed for digital signal processing in the 1960s through 1980s, including efficient structures for bit-serial multiplication and accumulation.