Search results
Results from the WOW.Com Content Network
A throttle body is somewhat analogous to the carburetor in a non-injected engine, although it is important to remember that a throttle body is not the same thing as a throttle, and that carbureted engines have throttles as well. A throttle body simply supplies a convenient place to mount a throttle in the absence of a carburetor venturi.
The rate of airflow through an internal combustion engine is an important factor determining the amount of power the engine generates. Most gasoline engines are controlled by limiting that flow with a throttle that restricts intake airflow, while a diesel engine is controlled by the amount of fuel supplied to the cylinder, and so has no "throttle" as such.
Fuel primer pump - A manual pump to add a small amount of fuel at the cylinder intakes to assist in starting a cold engine. Fuel-injected engines do not have this control. For fuel-injected engines, a fuel boost pump is used to prime the engine prior to start. Fuel quantity gauge - Indicates the amount of fuel remaining in the identified tank ...
Under part throttle conditions (i.e. when the throttle is less than fully open), the effective compression ratio is less than when the engine is operating at full throttle, due to the simple fact that the incoming fuel-air mixture is being restricted and cannot fill the chamber to full atmospheric pressure. The engine efficiency is less than ...
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Intake air throttling changes the amount of air sucked into the engine, which means that if a stoichiometric air-fuel mixture is desired, the amount of injected fuel has to be changed along with the intake air throttling. To do so, manifold injection systems have at least one way to measure the amount of air that is currently being sucked into ...
Rotaries had a number of disadvantages, notably very high fuel consumption, partially because the engine was typically run at full throttle, and also because the valve timing was often less than ideal. Oil consumption was also very high. Due to primitive carburetion and absence of a true sump, the lubricating oil was added to the fuel/air ...
A tube ensures flow of oil from the reservoir to the oil pump. This system is commonly used for motorcycles as it eliminates the need of pre-mixing fuel and two-stroke oil. Vespa is an example where pre-mixing of two-stroke oil is required. Automatic lubrication was introduced for motorcycles by Velocette in 1913. [1] An example of application ...