Search results
Results from the WOW.Com Content Network
Fuel primer pump - A manual pump to add a small amount of fuel at the cylinder intakes to assist in starting a cold engine. Fuel-injected engines do not have this control. For fuel-injected engines, a fuel boost pump is used to prime the engine prior to start. Fuel quantity gauge - Indicates the amount of fuel remaining in the identified tank ...
A throttle body is somewhat analogous to the carburetor in a non-injected engine, although it is important to remember that a throttle body is not the same thing as a throttle, and that carbureted engines have throttles as well. A throttle body simply supplies a convenient place to mount a throttle in the absence of a carburetor venturi.
Thrust levers of an A320 set to the autothrust position during cruise flight. An autothrottle (automatic throttle, also known as autothrust, A/T or A/THR) is a system that allows a pilot to control the power setting of an aircraft's engines by specifying a desired flight characteristic, rather than manually controlling the fuel flow.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
It is commonly used in engines with spark ignition that use petrol as fuel, such as the Otto engine, and the Wankel engine. In a manifold-injected engine, the fuel is injected into the intake manifold, where it begins forming a combustible air-fuel mixture with the air. As soon as the intake valve opens, the piston starts sucking in the still ...
Under part throttle conditions (i.e. when the throttle is less than fully open), the effective compression ratio is less than when the engine is operating at full throttle, due to the simple fact that the incoming fuel-air mixture is being restricted and cannot fill the chamber to full atmospheric pressure. The engine efficiency is less than ...