enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

3. Steel grades - Wikipedia

   en.wikipedia.org/wiki/Steel_grades

   Steel for pipe and tube: ... Below is a table comparing steel grades from different grading systems. Comparison of steel grades by chemistry [4] [5] [6] EN steel number

4. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Since the outside diameter is fixed for a given pipe size, the inside diameter will vary depending on the wall thickness of the pipe. For example, 2" Schedule 80 pipe has thicker walls and therefore a smaller inside diameter than 2" Schedule 40 pipe. Steel pipe has been produced for about 150 years.

5. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Seamless Steel Pipes and Tubes – Dimensions, Conventional Masses per Unit Length: Canceled: DIN EN 10220: EN 10220: DIN 2527: Blank flanges – Nominal pressure 6 to 100: Withdrawn: DIN EN 1092-1: EN 1092-1: DIN 2860: Capillary Fittings; Bends 180° of Copper: Withdrawn: DIN 2982: Steel threaded pipe fittings: Withdrawn: DIN EN 10241: EN ...

6. ASTM A53 steel - Wikipedia

   en.wikipedia.org/wiki/ASTM_A53_steel

   4. Materials and Manufacture of ASTM A53 Pipes 4.1 The steel for both seamless and welded pipe shall be made by one or more of the following processes: open-hearth, electric-furnace, or basic-oxygen. 4.2 If steels of different grades are sequentially strand cast, identification of the resultant transition material is required.

7. Standard dimension ratio - Wikipedia

   en.wikipedia.org/wiki/Standard_dimension_ratio

   Standard dimension ratio (SDR) is a method of rating a pipe's durability against pressure. The standard dimension ratio describes the correlation between the pipe dimension and the thickness of the pipe wall. [1] Common nominations are SDR11, SDR17, SDR26 and SDR35. Pipes with a lower SDR can withstand higher pressures.