Search results
Results from the WOW.Com Content Network
Stanley and Veritas marking gauges. A marking gauge, also known as a scratch gauge, [1] is used in woodworking and metalworking to mark out lines for cutting or other operations. [2] The purpose of the gauge is to scribe a line parallel to a reference edge or surface. It is used in joinery and sheetmetal operations.
A wood scribe is a tool for marking wood by scratching the surface visibly. A wood scribe is often used with a try square for accurate scribing. A marking gauge is a more specific form of wood scribe used to accurately mark wood for cutting, often for laying out mortise and tenon joints.
Some marking knives incorporate a marking knife blade at one end, and a scratch awl tip at the other end – but because of this they are sometimes considered dangerous to use. [ 3 ] [ 1 ] Marking knives are either made from a single piece of steel, or additionally have a handle made of wood or plastic.
Like the simpler marking gauge, a mortise gauge has a locking thumb screw slide for adjusting the distance of the scribe from the edge of the wood. It has two protruding pins, often called "spurs", [ 3 ] which are designed to scribe parallel lines marking both sides of a mortise at the same time. [ 4 ]
If you can't see the image, make sure your browser preferences are set to display images and try again. Alternatively, you can listen to the image challenge by clicking on the audio icon. Display images in Edge Display images in Safari Display images in Firefox Display images in Google Chrome Display images in Internet Explorer
Marking out or layout means the process of transferring a design or pattern to a workpiece, as the first step in the manufacturing process. [1] It is performed in many industries or hobbies although in the repetition industries the machine's initial setup is designed to remove the need to mark out every individual piece.
The scratch awl is basically a steel spike with its tip sharpened to a fine point. The tip of the spike is drawn across the timber, leaving a shallow groove. It may also be used to mark a point by pressing the tip into the timber. [2] It is generally used when dimensioning and for laying out with the grain. It may also be used across the grain.
Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle. [7] [2]