Search results
Results from the WOW.Com Content Network
Various terms for the length of a fixed object are used, and these include height, which is vertical length or vertical extent, width, breadth, and depth. Height is used when there is a base from which vertical measurements can be taken. Width and breadth usually refer to a shorter dimension than length. Depth is used for the measure of a third ...
Tablet cases sizes Tablet PC Height Width Depth Screen Case size Acer Iconia Tab A500 [1]: 10.2 in (260 mm) 7 in (180 mm) 0.52 in (13 mm) 10.1 in (260 mm)
Lawrence, citing Masters and Johnson's Human Sexual Response (1966), states that pages 73 and 74 of that book show that typical vaginal depth in Masters and Johnson's participants ranged from 7–8 cm (2.8–3.1 in) in an unstimulated state, to 11–12 cm (4.3–4.7 in) during sexual arousal with a speculum in place.
[Proportion] should not be confused with a ratio, involving two magnitudes. Modern usage tends to substitute "proportion" for a comparison involving two magnitudes (e.g., length and width), and hence mistakes a mere grouping of simple ratios for a complete proportion system, often with a linear basis at odds with the areal approach of Greek ...
The size and proportions of a book depend on the size of the original full sheet. If a sheet 480 by 640 mm (19 by 25 in) is used to print a quarto, the resulting untrimmed pages, will be approximately half as large in each dimension: width 240 mm (9 + 1 ⁄ 2 in) and height 320 mm (12 + 1 ⁄ 2 in).
More specifically, geometrical size (or spatial size) can refer to three geometrical measures: length, area, or volume. Length can be generalized to other linear dimensions (width, height, diameter, perimeter). Size can also be measured in terms of mass, especially when assuming a density range.
Air draft is the minimum height a ship needs to pass under, while standard draft is the minimum depth a ship needs float over. Length between perpendiculars – The distance between where the forward part cuts the waterline and the rudder post of the ship.
Common screen dimensions are listed in the table below (the most common diagonal dimensions in inches as of 2020 are bolded). If the display is not listed, then the following equations can be used. Note that D is the diagonal (in centimeters or inches), W is the width (in pixels), and H is the height (in pixels).