Search results
Results from the WOW.Com Content Network
Liquid oxygen has a clear cyan color and is strongly paramagnetic: it can be suspended between the poles of a powerful horseshoe magnet. [2] Liquid oxygen has a density of 1.141 kg/L (1.141 g/ml), slightly denser than liquid water, and is cryogenic with a freezing point of 54.36 K (−218.79 °C; −361.82 °F) and a boiling point of 90.19 K (−182.96 °C; −297.33 °F) at 1 bar (15 psi).
This article gives a list of conversion factors for several physical quantities. ... ≡ 240 mL [18] = 2.4 × 10 −4 m ... Ratio of the speed to the speed of sound ...
The expansion ratio of liquefied and cryogenic from the boiling point to ambient is: nitrogen – 1 to 696; liquid helium – 1 to 745; argon – 1 to 842; liquid hydrogen – 1 to 850; liquid oxygen – 1 to 860; neon – Neon has the highest expansion ratio with 1 to 1445. [3] [4]
A solution with 1 g of solute dissolved in a final volume of 100 mL of solution would be labeled as "1%" or "1% m/v" (mass/volume). This is incorrect because the unit "%" can only be used for dimensionless quantities. Instead, the concentration should simply be given in units of g/mL.
In environmental chemistry, the chemical oxygen demand (COD) is an indicative measure of the amount of oxygen that can be consumed by reactions in a measured solution. It is commonly expressed in mass of oxygen consumed over volume of solution, which in SI units is milligrams per liter ( mg / L ).
Oxygen (chemical symbol O) has three naturally occurring isotopes: 16 O, 17 O, and 18 O, where the 16, 17 and 18 refer to the atomic mass.The most abundant is 16 O, with a small percentage of 18 O and an even smaller percentage of 17 O. Oxygen isotope analysis considers only the ratio of 18 O to 16 O present in a sample.
The "dilution factor" is an expression which describes the ratio of the aliquot volume to the final volume. Dilution factor is a notation often used in commercial assays. For example, in solution with a 1/5 dilution factor (which may be abbreviated as x5 dilution ), entails combining 1 unit volume of solute (the material to be diluted) with ...
The limiting oxygen concentration (LOC), [1] also known as the minimum oxygen concentration (MOC), [2] is defined as the limiting concentration of oxygen below which combustion is not possible, independent of the concentration of fuel. It is expressed in units of volume percent of oxygen. The LOC varies with pressure and temperature.