enow.com Web Search

  1. Ads

    related to: shaft retainer clips

Search results

  1. Results from the WOW.Com Content Network
  2. Retaining ring - Wikipedia

    en.wikipedia.org/wiki/Retaining_ring

    A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing/bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly. Circlips are a type of retaining ring.

  3. R-clip - Wikipedia

    en.wikipedia.org/wiki/R-clip

    R-clips are commonly used to secure the ends of round shafts such as axles and clevis pins. The straight leg of the R-clip is pushed into a hole near one end of the shaft until the semicircular "belly" in the middle of the other, bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole.

  4. Circlip - Wikipedia

    en.wikipedia.org/wiki/Circlip

    A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement.

  5. Engineering fit - Wikipedia

    en.wikipedia.org/wiki/Engineering_fit

    Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

  6. End-face mechanical seal - Wikipedia

    en.wikipedia.org/wiki/End-face_mechanical_seal

    One group of parts is connected to the rotating shaft and the other to the machine's case. The spring keeps the elements tight against each other, maintaining the seal and allowing for wear. In mechanical engineering , an end-face mechanical seal (often shortened to mechanical seal ) is a type of seal used in rotating equipment, such as pumps ...

  7. Aerospace bearing - Wikipedia

    en.wikipedia.org/wiki/Aerospace_bearing

    Jet engine shaft bearings and accessory drive shaft bearings typically use single piece or two piece machined retainers. The pressed steel or moulded retainers found on mass-produced bearings are not used. Temperature and moisture resistant oils, greases and lubricants are normally specified.

  1. Ads

    related to: shaft retainer clips