Search results
Results from the WOW.Com Content Network
Air draft is the minimum height a ship needs to pass under, while standard draft is the minimum depth a ship needs to float over. Length between perpendiculars – The distance between where the forward part cuts the waterline and the rudder post of the ship.
A ship's draft/draught is the "depth of the vessel below the waterline measured vertically to the lowest part of the hull, propellers, or other reference point". [1] That is, the draft or draught is the maximum depth of any part of the vessel, including appendages such as rudders, propellers and drop keels if deployed.
The bow (/ b aʊ /) is the forward part of the hull of a ship or boat, [1] the point that is usually most forward when the vessel is underway. The aft end of the boat is the stern. [2] Prow may be used as a synonym for bow or it may mean the forward-most part of the bow above the waterline.
A sharp bow on a conventional hull form would produce waves and low drag like a bulbous bow, but waves coming from the side would strike it harder. The blunt bulbous bow also produces higher pressure in a large region in front, making the bow wave start earlier. [6] The addition of a bulb to a ship's hull increases its overall wetted area.
A vessel's length at the waterline (abbreviated to L.W.L) [1] is the length of a ship or boat at the level where it sits in the water (the waterline). The LWL will be shorter than the length of the boat overall (length overall or LOA) as most boats have bows and stern protrusions that make the LOA greater than the LWL. As a ship becomes more ...
The position of the summer load line is calculated from the load line rules and depends on many factors such as length of ship, type of ship, type and number of superstructures, amount of sheer, and bow height. The horizontal line through the circle of the Plimsoll mark is at the same level as the summer load line.
On container ships the position of containers are identified by a bay-row-tier coordinate system. The bays illustrate the cross sections of the ship and are numbered from bow to stern. The rows run the length of the ship and are numbered from the middle of the ship outwards, even numbers on the port side and odd numbers on the starboard side ...
If you draw a box around the submerged part of the ship, it is the ratio of the box volume occupied by the ship. It gives a sense of how much of the block defined by the L WL, beam (B) & draft (T) is filled by the hull. Full forms such as oil tankers will have a high C b where fine shapes such as sailboats will have a low C b.