enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Interrupts in 65xx processors - Wikipedia

    en.wikipedia.org/wiki/Interrupts_in_65xx_processors

    The detection of a RESET signal causes the processor to enter a system initialization period of six clock cycles, after which it sets the interrupt request disable flag in the status register and loads the program counter with the values stored at the processor initialization vector ($00FFFC – $00FFFD) before commencing execution. [1]

  3. Non-maskable interrupt - Wikipedia

    en.wikipedia.org/wiki/Non-maskable_interrupt

    With regard to SPARC, the non-maskable interrupt (NMI), despite having the highest priority among interrupts, can be prevented from occurring through the use of an interrupt mask. [1] An NMI is often used when response time is critical or when an interrupt should never be disabled during normal system operation.

  4. Interrupt flag - Wikipedia

    en.wikipedia.org/wiki/Interrupt_flag

    The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until

  5. FLAGS register - Wikipedia

    en.wikipedia.org/wiki/FLAGS_register

    FLAGS registers can be moved from or to the stack. This is part of the job of saving and restoring CPU context, against a routine such as an interrupt service routine whose changes to registers should not be seen by the calling code. Here are the relevant instructions: The PUSHF and POPF instructions transfer the 16-bit FLAGS register.

  6. Interrupt descriptor table - Wikipedia

    en.wikipedia.org/wiki/Interrupt_descriptor_table

    Processor exceptions generated by the CPU have fixed mapping to the first up to 32 interrupt vectors. [1] While 32 vectors (0x00-0x1f) are officially reserved (and many of them are used in newer processors), the original 8086 used only the first five (0-4) interrupt vectors and the IBM PC IDT layout did not respect the reserved range.

  7. Control register - Wikipedia

    en.wikipedia.org/wiki/Control_register

    Clock-comparator subclass mask 0 21 CPU-timer subclass mask 0 22 Service-signal subclass mask 0 24 Set to 1 0 25 Interrupt-key subclass mask 0 26 Set to 1 0 27 ETR subclass mask 0 28 Program-call-fast 0 29 Crypto control 1 0 Primary space-switch-event control 1 1-19 Primary segment-table origin 1 22 Primary subspace-group control 1 23

  8. Interrupt - Wikipedia

    en.wikipedia.org/wiki/Interrupt

    A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...

  9. Interrupt handler - Wikipedia

    en.wikipedia.org/wiki/Interrupt_handler

    Even in a CPU which supports nested interrupts, a handler is often reached with all interrupts globally masked by a CPU hardware operation. In this architecture, an interrupt handler would normally save the smallest amount of context necessary, and then reset the global interrupt disable flag at the first opportunity, to permit higher priority ...