Ads
related to: pouring concrete over existing surfaces drain wall venttemu.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
To install this, the doghouse manhole is lowered to have the two openings to slide over the existing pipe. The concrete is poured in to form the base with slopes from the precast concrete wall down to the half point of the existing pipe. This forms a half bench for the manhole base. The top half of that existing pipe is cut open to form a channel.
Once excavated, the walls are then power washed and allowed to dry. The dry walls are sealed with a waterproofing membrane, [3] and new drainage tiles (weeping tiles) are placed at the side of the footing. A French drain, PVC pipe, or other drainage system is installed and water is led further from the basement.
It is virtually impossible to make a concrete wall waterproof, over the long run, so drainage is the key. There are draining membranes that can be applied to the outside of the basement that create channels for water against the basement wall to flow to the foundation drains. [16] Where drainage is inadequate, waterproofing may be needed.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
The tremie concrete placement method uses a vertical or nearly vertical pipe, through which concrete is placed by gravity feed below water level. [4]The lower end of the pipe is kept immersed in fresh concrete so that concrete rising from the bottom displaces the water above it, thus limiting washing out of the cement content of the fresh concrete at the exposed upper surface.
Integral damp proofing in concrete involves adding materials to the concrete mix to make the concrete itself impermeable. [ 4 ] Surface suppressant coating with thin water proof materials such as epoxy resin for resistance to non-pressurized moisture such as rain water or a coating of cement sprayed on such as shotcrete which can resist water ...
Shotcrete, gunite (/ ˈ ɡ ʌ n aɪ t /), or sprayed concrete is concrete or mortar conveyed through a hose and pneumatically projected at high velocity onto a surface. This construction technique was invented by Carl Akeley and first used in 1907. [1]: 7 The concrete is typically reinforced by conventional steel rods, steel mesh, or fibers.
Cast-in-place concrete or Cast-in-situ concrete is a technology of construction of buildings where walls and slabs of the buildings are cast at the site in formwork. [1] This differs from precast concrete technology where slabs are cast elsewhere and then brought to the construction site and assembled. [ 2 ]
Ads
related to: pouring concrete over existing surfaces drain wall venttemu.com has been visited by 1M+ users in the past month