enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Mortise and tenon - Wikipedia

    en.wikipedia.org/wiki/Mortise_and_tenon

    A mortise and tenon (occasionally mortice and tenon) joint connects two pieces of wood or other material. Woodworkers around the world have used it for thousands of years to join pieces of wood, mainly when the adjoining pieces connect at right angles.

  3. Hammer-headed tenon - Wikipedia

    en.wikipedia.org/wiki/Hammer-headed_tenon

    The mortise is increased in size to receive a pair of folding wedges each side of the tenon. The hammer-headed key is used where there is no straight member to form the tenon. It is difficult to form a strong tenon on curved cut timber as the short grain there will weaken it, so two mortise sockets are formed one in each piece and a separate ...

  4. Domino joiner - Wikipedia

    en.wikipedia.org/wiki/Domino_joiner

    The original tool supported cutter sizes from 4 mm to 10 mm with available tenon sizes from 4x20 mm up to 10x50 mm. This allowed joints in stock as thin as 10 millimetres (0.39 in). Later a bigger tool was introduced allowing tenon sizes up to 14x140 mm, opening many carpentry use cases for the tool family.

  5. Phoenician joint - Wikipedia

    en.wikipedia.org/wiki/Phoenician_joint

    A Phoenician joint (Latin: coagmenta punicana) is a locked mortise and tenon wood joinery technique used in shipbuilding to fasten watercraft hulls.The locked (or pegged) mortise and tenon technique consists of cutting a mortise, or socket, into the edges of two planks and fastening them together with a rectangular wooden knob.

  6. Frame and panel - Wikipedia

    en.wikipedia.org/wiki/Frame_and_panel

    Mortise and tenon is the strongest, and is often used for large doors which will have greater stresses imposed. Bridle joints are typically used in less formal work, as the exposed endgrain is considered unattractive; while butt joints, being weak, are only used on very small assemblies.

  7. Mortiser - Wikipedia

    en.wikipedia.org/wiki/Mortiser

    Alternatively, the tenon can be rounded with a rasp to achieve an equally strong joint. For cutting small mortises, a normal drill bit can be used. However, for larger mortises, a common type of bit in modern mortisers is a Harry Watt square drill bit, in which a bit with a Reuleaux triangle cross section is allowed to "wobble" while it rotates ...

  8. Glossary of woodworking - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_woodworking

    An example is a "blind" mortise and tenon joint. bolster. Also called a pillow or cross head. 1. A shoulder. 2. A timber situated between a post and a beam to increase the bearing or shorten the span. bolt A piece of log cut to a specific length, usually a short length from which products such as shingles are split or cut.

  9. Talk:Mortise and tenon - Wikipedia

    en.wikipedia.org/wiki/Talk:Mortise_and_tenon

    The "shoulder" of a tenon is the part that forms the face of the non-tenon, from which the tenon protrudes. Splines don't have these and they don't form part of loose tenons (although there is still a shoulder in such joints). The reason that this matters is that a tenon without shoulders is just a stick.