Search results
Results from the WOW.Com Content Network
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
One or more logical or physical interfaces may have a VRF and these VRFs do not share routes. Therefore, the packets are only forwarded between interfaces on the same VRF. VRFs are the TCP/IP layer 3 equivalent of a VLAN. Because the routing instances are independent, the same or overlapping IP addresses can be used without conflicting with ...
VLAN cross connect (CC or VLAN-XC) is a mechanism used to create Switched VLANs, VLAN CC uses IEEE 802.1ad frames where the S Tag is used as a Label as in MPLS. IEEE approves the use of such a mechanism in part 6.11 of IEEE 802.1ad-2005 .
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Multiple VLAN Registration Protocol (for provider bridges) IEEE 802.1ad: 01-80-C2-00-00-0E: Local LAN Link, never crosses another device 0x88CC Link Layer Discovery Protocol (primary) 0x88F7 Precision Time Protocol (PTP) version 2 over Ethernet (802.1AS) 01-80-C2-00-00-21: 0x88F5 GARP VLAN Registration Protocol (also known as IEEE 802.1Q GVRP)
GARP was used by two applications: GARP VLAN Registration Protocol (GVRP) for registering VLAN trunking between multilayer switches, and by the GARP Multicast Registration Protocol (GMRP). The latter two were both mostly enhancements for VLAN-aware switches per definition in IEEE 802.1Q .
It is a set of one or more infrastructure basic service sets on a common logical network segment (i.e. same IP subnet and VLAN). [18] Key to the concept is that the participating basic service sets appear as a single network to the logical link control layer by using the same SSID.
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM).This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs).