Search results
Results from the WOW.Com Content Network
Cutoff grade is the minimum grade required in order for a mineral or metal to be economically mined (or processed). Material found to be above this grade is considered to be ore, while material below this grade is considered to be waste. [1] The cutoff grade can be determined through a variety of methods, each of varying complexity.
Examples include enclosed gear drives operating at low speeds and open gearing. Grades 0, 1 and 2 are used in highly loaded gearing. Grades 1 through 4 are often used in rolling contact bearings. Greases with a higher number are firmer, tend to stay in place and are a good choice when leakage is a concern.
Stellite alloys are a family of completely non-magnetic and corrosion-resistant cobalt alloys of various compositions that have been optimised for different uses. Stellite alloys are suited for cutting tools, an example is Stellite 100, because this alloy is quite hard, maintains a good cutting edge at high temperature, and resists hardening and annealing.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Material selection is often benefited by the use of material index or performance index relevant to the desired material properties. [2] For example, a thermal blanket must have poor thermal conductivity in order to minimize heat transfer for a given temperature difference. It is essential that a designer should have a thorough knowledge of the ...
Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...
Example: The following table shows the steps for sorting the sequence {3, 7, 4, 9, 5, 2, 6, 1}. In each step, the key under consideration is underlined. The key that was moved (or left in place because it was the biggest yet considered) in the previous step is marked with an asterisk.
Selection coefficient, usually denoted by the letter s, is a measure used in population genetics to quantify the relative fitness of a genotype compared to other genotypes. . Selection coefficients are central to the quantitative description of evolution, since fitness differences determine the change in genotype frequencies attributable to selecti