Search results
Results from the WOW.Com Content Network
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
Kitchen renovation spackling to cover holes and tape between sheetrock boards Drywall with joint compound applied.. Joint compound (also known as drywall compound, drywall mud, joint cement or mastic) is a white powder of primarily gypsum dust mixed with water to form a paste the consistency of cake frosting, which is spread onto drywall and sanded when dry to create a seamless base for paint ...
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Spackling paste is comparable and contrastable with joint compound as both look similar and serve the similar purpose of filling in low spots in walls and ceilings. [3] The chief differences are that spackling paste typically dries faster, shrinks less during drying, and is meant for smaller repairs, and not for a whole room or house.
Its main purpose is to direct water out of the cavity. Metal flashing usually extends from the interior wall through the outer wall and a weep hole with a downward curve allows the water to drain. Flashing systems in cavity walls are typically located close to the base of the wall, so that it will collect the water that goes down the wall.
When knocking this down, the mud is allowed to dry for a short period, then skimmed with a knockdown knife – a large, usually plastic (to reduce noticeable edges) knife. Knockdown texture reduces construction costs because it conceals imperfections in the drywall that normally require higher more expensive stages of sand and prime for drywall ...
A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.
Navigating wet leaves. That fall foliage can accumlate and get wet, creating a slippery surface that’s ripe for slips and falls. “If you have the ability, do not walk on wet leaves ...