enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Serial digital interface - Wikipedia

   en.wikipedia.org/wiki/Serial_digital_interface

   The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...

3. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Broadcast video. Variants include SD-SDI, HD-SDI, Dual Link HD-SDI, 3G-SDI, 6G-SDI, 12G-SDI. [10] High-Definition Multimedia Interface (HDMI) 2003: 19 pin HDMI Type A/C: 10240 x 4320 @ 120 (version 2.1) [11] Many A/V systems and video cards (including motherboards with IGP) High-bandwidth Digital Content Protection (HDCP) encryption is ...

4. Video router - Wikipedia

   en.wikipedia.org/wiki/Video_router

   Two video matrix units in a rack. A video router, also known as a video matrix switch or SDI router, is an electronic switch designed to route video signals from multiple input sources such as cameras, VT/DDR, computers and DVD players, to one or more display devices, such as monitors, projectors, and TVs.

5. SMPTE 292 - Wikipedia

   en.wikipedia.org/wiki/SMPTE_292

   SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...

6. SMPTE 424M - Wikipedia

   en.wikipedia.org/wiki/SMPTE_424M

   These bit-rates are sufficient for 1080p video at 50 or 60 frames per second. [1] The initial 424M standard was published in 2006, with a revision published in 2012 (SMPTE ST 424:2012). [ 2 ] This standard is part of a family of standards that define a serial digital interface (SDI); it is commonly known as 3G-SDI .

7. SMPTE 259M - Wikipedia

   en.wikipedia.org/wiki/SMPTE_259M

   SMPTE 259M is a standard published by SMPTE which "describes a 10-bit serial digital interface operating at 143/270/360 Mb/s." [1]The goal of SMPTE 259M is to define a serial digital interface (based on a coaxial cable), called SDI or SD-SDI.