Search results
Results from the WOW.Com Content Network
The list of drainage basins by area identifies basins (also known as "catchments" or, in North American usage, "watersheds"), sorted by area, which drain to oceans, mediterranean seas, rivers, lakes and other water bodies. All basins larger than 400,000 km 2 (150,000 sq mi) are included
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
A large basin wrench Large basin wrench, with jaws oriented to apply torque in counter-clockwise direction. A basin wrench, sometimes called a sink wrench, is a plumbing tool which is used in confined spaces to turn fasteners and pipes that would be difficult or impossible to reach with a plumber wrench or other types of wrenches. [1]
A drainage basin is an area of land in which all flowing surface water converges to a single point, such as a river mouth, or flows into another body of water, such as a lake or ocean. A basin is separated from adjacent basins by a perimeter, the drainage divide, [1] made up of a succession of elevated features, such as ridges and hills.
Dry pond on brook to reduce floods, near Děčín, Czech Republic. A detention basin or retarding basin is an excavated area installed on, or adjacent to, tributaries of rivers, streams, lakes or bays to protect against flooding and, in some cases, downstream erosion by storing water for a limited period of time.
Storm water is typically channeled to a retention basin through a system of street and/or parking lot storm drains, and a network of drain channels or underground pipes.. The basins are designed to allow relatively large flows of water to enter, but discharges to receiving waters are limited by outlet structures that function only during very large storm eve
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.
Each subregion includes the area drained by a river system, a reach of a river and its tributaries in that reach, a closed basin or basins, or a group of streams forming a coastal drainage area. [6] Regions receive a two-digit code. The following levels are designated by the addition of another two digits. [7]