Search results
Results from the WOW.Com Content Network
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
George Caramagna, a mechanic working on the suspension system, suggested installing a stabilizer (anti-roll or "anti-sway") bar, but was overruled by GM management. [citation needed] To make up for the cost-cutting lack of a front stabilizer bar, Corvairs required tire pressures which were outside of the tire manufacturers' recommended tolerances.
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
Second-generation Corvairs (1965–1969) used a true independent rear suspension (IRS) system. The Hillman Imp designers learned from the problems with the Corvair, having crashed [4] one at a relatively low speed, and they designed their rear-engined car with a semi-trailing arm suspension at the rear. To attain correct handling balance, they ...
Hydropneumatic suspension is a type of motor vehicle suspension system, invented by Paul Magès, produced by Citroën, and fitted to Citroën cars, as well as being used under licence by other car manufacturers. Similar systems are also widely used on modern tanks and other large military vehicles.
In France in 1954, Citroën introduced the first self-levelling rear suspension on a production car, and then in 1955 pioneered self-levelling of all four wheels, using its hydropneumatic system. These cars maintain an exact height over the road when the engine is on - height control valves attached to the roll bars via linkages would open to ...
With modern drive by wire fuel controls, problems are believed to occur exclusively while the vehicle is under way. General Motors cars of the 1950s with automatic transmissions have the R for reverse at the furthest clockwise position in the rotation of the column-mounted shift lever. L for low position is just adjacent as the lever moves one ...
Despite the drawbacks, the MacPherson strut set-up is still used on some high performance cars, because they tend to have relatively small suspension travel, and so do not have the same kinematic problems. Up until the 1989 model year (964), Porsche 911 used a similar strut design that did not have coil springs, using torsion bar suspension ...