Search results
Results from the WOW.Com Content Network
Osmium is a hard, brittle, blue-gray metal, and the densest stable element—about twice as dense as lead. The density of osmium is slightly greater than that of iridium ; the two are so similar (22.587 versus 22.562 g/cm 3 at 20 °C) that each was at one time considered to be the densest element.
Help; Learn to edit; Community portal; Recent changes; Upload file; Special pages
A ductile material must have a high degree of plasticity and strength so that large deformations can take place without failure or rupture of the material. In ductile extension, a material that exhibits a certain amount of elasticity along with a high degree of plasticity. [3] Durability: Ability to withstand wear, pressure, or damage; hard-wearing
The characteristic properties of elemental metals and nonmetals are quite distinct, as shown in the table below. Metalloids, straddling the metal-nonmetal border , are mostly distinct from either, but in a few properties resemble one or the other, as shown in the shading of the metalloid column below and summarized in the small table at the top ...
As quoted in an online version of: David R. Lide (ed), CRC Handbook of Chemistry and Physics, 84th Edition.CRC Press. Boca Raton, Florida, 2003; Section 4, Properties of the Elements and Inorganic Compounds; Physical Properties of the Rare Earth Metals
The magnetic properties of electrical steel are dependent on heat treatment, as increasing the average crystal size decreases the hysteresis loss. Hysteresis loss is determined by a standard Epstein tester and, for common grades of electrical steel, may range from about 2 to 10 watts per kilogram (1 to 5 watts per pound) at 60 Hz and 1.5 tesla ...
The failure of a material is usually classified into brittle failure or ductile failure . Depending on the conditions (such as temperature, state of stress, loading rate) most materials can fail in a brittle or ductile manner or both. However, for most practical situations, a material may be classified as either brittle or ductile.
Intermetallic compounds are generally brittle at room temperature and have high melting points. Cleavage or intergranular fracture modes are typical of intermetallics due to limited independent slip systems required for plastic deformation. However, some intermetallics have ductile fracture modes such as Nb–15Al–40Ti.