Search results
Results from the WOW.Com Content Network
A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...
A starter solenoid is an electromagnet which is actuated to engage the starter motor of an internal combustion engine. It is normally attached directly to the starter motor which it controls. Its primary function is as the actuating coil of a contactor (a relay designed for large electric currents) which connects the battery to the starter ...
However, many new vehicles have been equipped with so-called "keyless" systems, which replace the key switch with a push button that also requires a transponder signal. The ignition locking system may be sometimes bypassed by disconnecting the wiring to the switch and manipulating it directly; this is known as hotwiring .
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
A Bendix drive is a type of engagement mechanism used in starter motors of internal combustion engines.The device allows the pinion gear of the starter motor to engage or disengage the ring gear (which is attached to the flywheel or flexplate of the engine) automatically when the starter is powered or when the engine fires, respectively.
Vehicles with a smart-key system can disengage the immobilizer and activate the ignition without inserting a key in the ignition, provided the driver has the key inside the car. On most vehicles, this is done by pressing a starter button or twisting an ignition switch .
Replacement keys, which can be purchased through the dealer or a 3rd party, must be compatible with the vehicle. Before the key can be used to start the vehicle it must be programmed, done by inserting the original key(s) as well as the new key into the ignition. With PATS I, programming of a new key can be done with just one working key.
A remote starter is a radio controlled device, which is installed in a vehicle by the factory or an aftermarket installer to preheat or cool the vehicle before the owner gets into it. [1] Once activated, by pushing a button on a special key chain remote, it starts the vehicle automatically for a predetermined time.