Search results
Results from the WOW.Com Content Network
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The 5.5 GHz cantenna dimensions are almost perfect in that they make a good fit for the standard TV satellite dish. The resulting setup is a low-cost high-quality high-gain antenna. [6] Such setups are widely used in wireless community networks for long-distance Wi-Fi links. Cantennas may be used with other RF devices such as wireless security ...
Typically a transmitter design includes generation of a carrier signal, which is normally [3] sinusoidal, optionally one or more frequency multiplication stages, a modulator, a power amplifier, and a filter and matching network to connect to an antenna. A very simple transmitter might contain only a continuously running oscillator coupled to ...
ANT was designed for low-bit-rate and low-power sensor networks, in a manner conceptually similar to (but not compatible with) Bluetooth Low Energy. [3] This is in contrast with normal Bluetooth, which was designed for relatively high-bit-rate applications such as streaming sound for low-power headsets.
4×4 array of 2.4 GHz patch antenna elements Patch antenna gain pattern. A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane.
A planar inverted-F antenna (PIFA) is used for wireless circuitry implemented in microstrip.The microstrip format is the format of choice for modern RF electronics. It can be used to implement required distributed-element RF components such as filters, while at the same time being economical because the same mass production methods are used as for printed circuit boards.
The loss in that feed line is 3.2 dB at 1 GHz; approximately 5 dB at the GPS frequency (1.575 42 GHz). This feed line loss can be avoided by placing an LNA at the antenna, which supplies enough gain to offset the loss. An LNA is a key component at the front-end of a radio receiver circuit to help reduce unwanted noise in particular.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...