Search results
Results from the WOW.Com Content Network
Compressed hydrogen is a storage form whereby hydrogen gas is kept under pressures to increase the storage density. Compressed hydrogen in hydrogen tanks at 350 bar (5,000 psi) and 700 bar (10,000 psi) are used for hydrogen tank systems in vehicles, based on type IV carbon-composite technology.
A hydrogen tank on a Honda FCX platform. A hydrogen tank (other names- cartridge or canister) is used for hydrogen storage. [89] [90] [91] The first type IV hydrogen tanks for compressed hydrogen at 700 bars (70 MPa; 10,000 psi) were demonstrated in 2001, the first fuel cell vehicles on the road with type IV tanks are the Toyota FCHV, Mercedes ...
Electrode active areas of metal hydride fuel cells have been scaled up from 60 cm 2 to 250 cm 2, enabling systems to be scaled up to 500 Watts. [11] The scaling up of electrode active areas also provided capabilities to develop higher power fuel cell stacks, each with 1500 Watts of power. [6]
A hydride compressor is a hydrogen compressor based on metal hydrides with absorption of hydrogen at low pressure, releasing heat, and desorption of hydrogen at high pressure, absorbing heat, by raising the temperature with an external heat source like a heated waterbed or electric coil. [1] [2] [3] [4]
Activity included NiMH batteries, solid-state hydrogen fuel storage, metal hydride fuel cells, and solar. Founder Stanford Ovshinsky was honored as "Hero for the planet" by Time magazine in 1999, and inducted into the U.S.-based Solar Energy Hall of Fame in 2005. [4]
Mirai cutaway showing the power control unit and the electric traction motor in the front, the fuel cell stack and hydrogen storage tank in the middle, and the nickel–metal hydride rechargeable battery above in the rear. The Mirai's fuel cell stack. The first generation of Toyota FC Stack achieved a maximum output of 114 kW (153 hp; 155 PS).
In 2009, Zurek et al. predicted that the alloy LiH 6 would be a stable metal at only one quarter of the pressure required to metallize hydrogen, and that similar effects should hold for alloys of type LiH n and possibly "other alkali high-hydride systems", i.e. alloys of type XH n, where X is an alkali metal. [20]
The hydrogen atoms occupy interstitial sites in palladium hydride. The H–H bond in H 2 is cleaved. The ratio in which H is absorbed on Pd is defined by = [] [].When Pd is brought into a H 2 environment with a pressure of 1 atm, the resulting concentration of H reaches x ≈ 0.7.