Search results
Results from the WOW.Com Content Network
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Different software is used by different motherboards. There are also third-party programs that work on a variety of motherboards and allow wide customization of fan behavior depending on temperature readings from the motherboard, CPU, and GPU sensors, as well as allowing manual control. Two such programs are SpeedFan [11] and Argus Monitor. [12]
The Atari ST series has a digital-to-analog converter of 3-bits, eight levels per RGB channel, featuring a 9-bit RGB palette (512 colors).Depending on the (proprietary) monitor type attached, it displays one of the 320×200, 16-colors and 640×200, 4-colors modes with the color monitor, or the high resolution 640×400 black and white mode with the monochrome monitor.
A single connector must be used for each signal. SCART: Consumer electronics, mostly in Europe. Carries analog stereo sound, along with composite video and/or RGB video. Some devices also support S-Video, which shares the same pins as composite video and RGB. YP B P R is also sometimes supported as a non-standard extension via the RGB pins. D ...
The system was designed "split-level", with the motherboard screwed onto the underside of the computer case and connected to the ISA bus backplane in the top section of the case via the video card which, rather than occupying an ISA slot, has two female edge connectors and plugs onto the ends of both the motherboard and the backplane, doubling ...
The System Management Bus (SMBus or SMB) is a single-ended simple two-wire bus for the purpose of lightweight communication. Most commonly it is found in chipsets of computer motherboards for communication with the power source for ON/OFF instructions.
This allows the motherboard to remove power upon shutdown (with the exception of the aforementioned 5V standby power, which is always on), and also to "wake up" the computer by events such as key presses, mouse clicks, "wake on lan" events, and scheduled alarm times. These "wakeup" features are often configurable via the BIOS/CMOS setup.
For example, with older PC systems, CPU speed and voltage settings were often made by setting jumpers. Some documentation may refer to setting the jumpers to on, off, closed, or open. When a jumper is on or covering at least two pins it is a closed jumper, when a jumper is off, is covering only one pin, or the pins have no jumper it is an open ...