Search results
Results from the WOW.Com Content Network
40G Transceiver Form Factors The QSFP+ form factor is specified for use with the 40 Gigabit Ethernet. Copper direct attached cable (DAC) or optical modules are supported, see Figure 85–20 in the 802.3 spec. QSFP+ modules at 40 Gbit/s can also be used to provide four independent ports of 10 gigabit Ethernet. [1] 100G Transceiver Form Factors
1000BASE-SX GBIC. Gigabit interface converter (GBIC) is a standard for transceivers.First defined in 1995, it was used with Gigabit Ethernet and Fibre Channel.By standardizing on a hot swappable electrical interface, a single gigabit port can support a wide range of physical media, from copper to long-wave single-mode optical fiber, at lengths of hundreds of kilometers.
A 10 Gigabit Ethernet XFP transceiver, top, and a SFP+ transceiver, bottom. The SFP+ (enhanced small form-factor pluggable) is an enhanced version of the SFP that supports data rates up to 16 Gbit/s. The SFP+ specification was first published on May 9, 2006, and version 4.1 was published on July 6, 2009. [31]
A ready-to-use module is a complete system with a transceiver, and optionally an MCU and antenna on a printed circuit board. While most of the modules in this list are Zigbee , Thread , ISA100.11a , or WirelessHART modules, some don't contain enough flash memory to implement a Zigbee stack and instead run plain 802.15.4 protocol, sometimes with ...
This is accomplished using a passive splitter prism inside each transceiver. Other, non-standard higher-powered single-strand optics commonly known as "BiDi" (bi-directional) utilize wavelength pairs in the 1490/1550 nm range, and are capable of reaching distances of 20, 40 and 80 km, or greater depending on module cost, fiber path loss ...
An optical module is a typically hot-pluggable optical transceiver used in high-bandwidth data communications applications. Optical modules typically have an electrical interface on the side that connects to the inside of the system and an optical interface on the side that connects to the outside world through a fiber optic cable.
The Cisco Nexus series switches are modular and fixed port network switches designed for the data center. Cisco Systems introduced the Nexus Series of switches on January 28, 2008. The first chassis in the Nexus 7000 family is a 10-slot chassis with two supervisor engine slots and eight I/O module slots at the front, as well as five crossbar ...
Download as PDF; Printable version; In other projects ... 40G may refer to: Valle Airport's FAA identifier; 40 Gigabit Ethernet, a networking standard; see 100 ...