Search results
Results from the WOW.Com Content Network
inviot U1 (arduino-compatible) all-in-one board with LCD, rotary encoder, RTC DS3231, EEPROM, buzzer, push buttons, RGB Led, NRF24 plug, and ESP8266 plug. Added features: ATmega328P-PU with UNO bootloader; LCD 20x4 2004; Rotary encoder; 2x push buttons, RGB Led, power led; Buzzer; RTC clock DS3231; EEPROM; NRF24 plug; ESP8266 plug; SD card ...
Arduino IDE support with 16/256/320 MHz presets and port of Arduino library. Also works with standard C/C++, stdio, gdb from the shell. Hardware multiply (4 cycle) and divide (32 cycle). DAQduino: PICcircuit.com PIC18F2550 or PIC18F2553 DAQduino is iCP12 usbStick that built in Arduino form of external ports connection.
A push-button (also spelled pushbutton) or simply button is a simple switch mechanism to control some aspect of a machine or a process. Buttons are typically made out of hard material, usually plastic or metal. [1] The surface is usually flat or shaped to accommodate the human finger or hand, so as to be easily depressed or pushed.
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.
A C/C++ library called libmaple is available to make it easier to migrate from Arduino. OLIMEXINO-STM32 board by Olimex has a STM32F103RBT6 microcontroller and similar to the Maple board. Netduino with support for .NET Micro Framework. ST Nucleo-64 and Nucleo-144 boards have female pin headers for Arduino shields too. (see Nucleo section below)
They enable computer control via networked switches, but do not require it. Their cost is about the same as the older "dimmability" circuitry that they replace in LED bulbs, fixtures or drivers. A residential-type dimmer switch with sliding knob to change brightness. The device is small enough to fit into a regular wall box provided for a switch.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
A latching switch is a switch that maintains its state after being activated. [1] A push-to-make, push-to-break switch would therefore be a latching switch – each time you actuate it, whichever state the switch is left in will persist until the switch is actuated again.