enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   Wheels with Asanti 28 in (710 mm) rims on a police Hummer H2 car. The wheel size is the size designation of a wheel given by its diameter, width, and offset. The diameter of the wheel is the diameter of the cylindrical surface on which the tire bead rides. The width is the inside distance between the bead seat faces.

3. Gear inches - Wikipedia

   en.wikipedia.org/wiki/Gear_inches

   For bicycles with 700c wheels, some cyclists quote gear inches based on a nominal wheel diameter of 27 inches, corresponding to the old British tire size of 27 x 1 + 1 ⁄ 4" (ETRTO 630). Strictly speaking, the rolling diameter of a 700c wheel may be significantly higher or lower than 27", depending on the tire size, e.g. nearly 27.5" for a ...

4. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

5. ISO 5775 - Wikipedia

   en.wikipedia.org/wiki/ISO_5775

   It is designed to make tire sizing consistent and clear. It replaces overlapping informal systems that ambiguously distinguished between sizes. For example, at least 6 different "26 inch" sizes exist (just by American notation), and "27 inch" wheels have a larger diameter than American "28 inch" (French "700C") wheels.

6. Bicycle and motorcycle geometry - Wikipedia

   en.wikipedia.org/wiki/Bicycle_and_motorcycle...

   Wheel flop refers to steering behavior in which a bicycle or motorcycle tends to turn more than expected due to the front wheel "flopping" over when the handlebars are rotated. Wheel flop is caused by the lowering of the front end of a bicycle or motorcycle as the handlebars are rotated away from the "straight ahead" position.

7. Speeds and feeds - Wikipedia

   en.wikipedia.org/wiki/Speeds_and_feeds

   Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.

8. Technical FAQ: AXS chain roller size explained, AXS/11-speed ...

   www.aol.com/news/technical-faq-axs-chain-roller...

   For premium support please call: 800-290-4726 more ways to reach us

9. Wheel speed sensor - Wikipedia

   en.wikipedia.org/wiki/Wheel_speed_sensor

   This correction enables a larger maximum permissible air gap at the speed sensor. On a module m = 1 target wheel these new sensors can tolerate an air gap of 1.4 mm, which is wider than that for conventional speed sensors on module m = 2 target wheels. On a module m = 2 target wheel the new speed sensors can tolerate gap of as much as 2.2 mm.