Search results
Results from the WOW.Com Content Network
Exact HO scale (half O of 7 mm = 1 foot) 1:87: 3.503 mm: Model railways (HO/h0) Civilian and military vehicles. Often used to describe HO scale. Original nominal 25 mm figure scale; though a 6-foot human in 1:87 is closer to 21 mm. 1:82: 3.717 mm An intermediate scale (HO/OO) intended to apply to both HO and OO scale train sets.
H0 or 3.5 mm: 1:87: 16.5 mm (0.65 in) H0 scale was introduced in Britain in the 1920s, and although it stayed as the most common worldwide modelling scale, in Britain H0 has little commercial availability and is generally only used to model the British prototype by a small number of modellers. 00 or 4 mm: 1:76: 16.5 mm (0.65 in)
One scale foot is equivalent to approximately 12/200 of an inch, 0.06 inches and 1.524 millimetres. One scale yard is equivalent to approximately 1/36 of an inch, 0.18 inches and 4.572 millimetres. Figure scale is 8 mm generally squared off to 1/190 – 1/220 scale. 10 mm: ≈1.667 mm - ≈1.9 mm: ≈1:182 - 1:160
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
To help compare different orders of magnitude, this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm). 1.0 mm – 1/1,000 of a meter; 1.0 mm – 0.03937 inches or 5/127 (exactly) 1.0 mm – side of a square of area 1 mm²; 1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27]
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM , together with the previously adopted conversion factor.