Search results
Results from the WOW.Com Content Network
Since the control signals for a serial port can be driven by any digital signal, some applications used the control lines of a serial port to monitor external devices, without exchanging serial data. A common commercial application of this principle was for some models of uninterruptible power supply which used the control lines to signal loss ...
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
So, for example, the diameter of a 2-cube is 2. In a hypercube system with eight processors and each processor and memory module being placed in the vertex of a cube, the diameter is 3. In general, a system that contains 2^N processors with each processor directly connected to N other processors, the diameter of the system is N.
An example of data mining related to an integrated-circuit (IC) production line is described in the paper "Mining IC Test Data to Optimize VLSI Testing." [12] In this paper, the application of data mining and decision analysis to the problem of die-level functional testing is described. Experiments mentioned demonstrate the ability to apply a ...
Traditional serial communications are normally implemented using a device known as a UART, which translates data from the computer bus's internal parallel format to serial and back. This allows the computer to send data serially simply by doing a regular parallel write to an I/O register, and the UART will convert this to serial form and send it.
A serial computer is not necessarily the same as a computer with a 1-bit architecture, which is a subset of the serial computer class. 1-bit computer instructions operate on data consisting of single bits, whereas a serial computer can operate on N-bit data widths, but does so a single bit at a time.
The ccTalk multidrop bus protocol uses an 8 bit TTL-level asynchronous serial protocol.It uses address randomization to allow multiple similar devices on the bus (after randomisation the devices can be distinguished by their serial number). ccTalk was developed by CoinControls, but is used by multiple vendors.