enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   (The axial movement of cones is not mandatory, however; a split bushing squeezed radially with a linear force—e.g., set screw, solenoid, spring clamp, pneumatic or hydraulic cylinder—achieves the same principle without the cones; but concentricity can only be had to the extent that the bushing's diameters are perfect for the particular ...

4. Vise - Wikipedia

   en.wikipedia.org/wiki/Vise

   An engineer's vise, also known as a metalworking vise, machinist's vise, or, informally, a "bench vise", is used to clamp metal instead of wood. It is used to hold metal when filing or cutting. It is sometimes made of cast steel or malleable cast iron, but most are made of cast iron. The jaws are often separate and replaceable, usually engraved ...

5. Cleco (fastener) - Wikipedia

   en.wikipedia.org/wiki/Cleco_(fastener)

   Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.

6. Locking pliers - Wikipedia

   en.wikipedia.org/wiki/Locking_pliers

   A typical use would be to hold metal parts in place for welding. Other uses include holding a nut or bolt that has been 'rounded', helping pull out nails, holding pipes without squeezing them, and acting as temporary substitute levers or knobs on equipment and machinery.

7. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   This type of collet holds the external surface of the tool or workpiece being clamped. This is the most usual type of collet chuck. An external collet clamps against the internal surface or bore of a hollow cylinder. The collet's taper is internal and the collet expands when a corresponding taper is drawn or forced into the collet's internal taper.