enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gas heater - Wikipedia

   en.wikipedia.org/wiki/Gas_heater

   Another example of a non-flued gas heater, running on natural gas. Non-flued heaters – also known as unvented heaters, vent-free heaters, or flueless fires, may be either permanently installed or portable, and sometimes incorporate a catalytic converter. [1] Non-flued heaters can be risky if appropriate safety procedures are not followed.

3. Catalytic heater - Wikipedia

   en.wikipedia.org/wiki/Catalytic_heater

   The following substances are able to help oxidize a fuel for a catalytic heater at a useful rate: Platinum can be used with natural gas, propane and butane. It generates a surface temperature of 300–550 °C, lower than the 760 °C ignition point. [6] Pt heaters are the most common type. [7] Palladium can be used with

4. Patio heater - Wikipedia

   en.wikipedia.org/wiki/Patio_heater

   The below table correlates to the approximate power (BTU / Watts) required. Results may vary based on the outside temperature, obstructions and wind. Area Distance from heater Propane and natural gas heaters Electric heaters 4 sq ft 1 foot 10,000 BTUs 1,000 Watts 16 sq ft 2 feet 36 sq ft 3 feet 64 sq ft 4 feet 100 sq ft 5 feet 46,000 BTUs 144 sq ft

5. Gas burner - Wikipedia

   en.wikipedia.org/wiki/Gas_burner

   Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...

6. Fireplace - Wikipedia

   en.wikipedia.org/wiki/Fireplace

   Ventless fireplaces (duct free/room-venting fireplaces) are fueled by either gel, liquid propane, bottled gas or natural gas. [clarification needed] In the United States, some states and local counties have laws restricting these types of fireplaces. They must be properly sized to the area to be heated. [4]

7. Heat of combustion - Wikipedia

   en.wikipedia.org/wiki/Heat_of_combustion

   By convention, the (higher) heat of combustion is defined to be the heat released for the complete combustion of a compound in its standard state to form stable products in their standard states: hydrogen is converted to water (in its liquid state), carbon is converted to carbon dioxide gas, and nitrogen is converted to nitrogen gas.