Search results
Results from the WOW.Com Content Network
A patch antenna is a narrowband, wide-beam antenna fabricated by etching the antenna element pattern in metal trace bonded to an insulating dielectric substrate, such as a printed circuit board, with a continuous metal layer bonded to the opposite side of the substrate which forms a ground plane. Common microstrip antenna shapes are square ...
An antenna like effect is achieved by periodic swing of electrons from its capacitive element to the ground plane which behaves like an inductor. The authors further argued that the operation of a dielectric antenna resembles the antenna conceived by Marconi, the only difference is that inductive element is replaced by the dielectric material. [5]
Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.
For antenna analysis, antenna placement, windscreen antennas, microstrip circuits, waveguide structures, radomes, EMI, cable coupling, FSS, metamaterials, periodic structures, RFID Elmer FEM: open source Yes Yes Yes Yes Yes manual, or can import other mesh formats FEM
A microstrip hairpin filter followed by a low pass stub filter on a PCB in a 20GHz Agilent N9344C spectrum analyser. For other (non-printed) technologies, short-circuit lines may be preferred since the short-circuit provides a mechanical attachment point for the line and Q-reducing dielectric insulators are not required for mechanical support ...
The ESR is a derived quantity representing the loss due to both the dielectric's conduction electrons and the bound dipole relaxation phenomena mentioned above. In a dielectric, one of the conduction electrons or the dipole relaxation typically dominates loss in a particular dielectric and manufacturing method. For the case of the conduction ...
Upper dielectric (B) is typically air. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known as "substrate". Microstrip lines are used to convey microwave-frequency signals.
Inevitably some antennas won't conveniently fit into any one basic type, so the last section on real antennas is an "everything else" category for a few peculiar antennas that don't fit cleanly into any of the categories or subcategories used in this article; for example, random wire antennas and antennas that are laid down on the ground ...