Search results
Results from the WOW.Com Content Network
A virtual local area network (VLAN) is any broadcast domain that is partitioned and isolated in a computer network at the data link layer (OSI layer 2). [ 2 ] [ 3 ] In this context, virtual refers to a physical object recreated and altered by additional logic, within the local area network .
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
Ethernet II framing is the most common in Ethernet local area networks, due to its simplicity and lower overhead. In order to allow some frames using Ethernet II framing and some using the original version of 802.3 framing to be used on the same Ethernet segment, EtherType values must be greater than or equal to 1536 (0x0600).
PBB-TE adapts Ethernet to carrier class transport networks. It is based on the layered VLAN tags and MAC-in-MAC encapsulation defined in IEEE 802.1ah (Provider Backbone Bridges (PBB)), but it differs from PBB in eliminating flooding, dynamically created forwarding tables, and spanning tree protocols. Compared to PBB and its predecessors, PBB-TE ...
The technique specified by the standard is known informally as stacked VLANs or QinQ. The original 802.1Q specification allows a single virtual local area network (VLAN) header to be inserted into an Ethernet frame. QinQ allows multiple VLAN tags to be inserted into a single frame, an essential capability for implementing metro Ethernet.
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
The next packets sent by the network can then be flooded and learned out of the (now enabled) secondary port without any network disruption. Fail-over times are demonstrably in the region of 50ms. The same switch can belong to multiple domains and thus multiple rings. However, these act as independent entities and can be controlled individually.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.