Search results
Results from the WOW.Com Content Network
The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the operation of the engine. The opening of the PCV valve during these conditions also compensates for the intake system being less effective at drawing crankcase gases into the intake ...
A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1] The intake valves control the flow of air/fuel mixture (or air alone for direct-injected engines) into the combustion chamber, while the exhaust valves control the flow of spent exhaust gases out of the ...
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
The butterfly valve often contains a small "idle cutout", a hole that allows small amounts of fuel/air mixture into the engine even when the valve is fully closed, or the carburetor has a separate air bypass with its own idle jet. If the engine is operating under light or no load and low or closed throttle, there is high manifold vacuum.
For a gasoline engine, the throttle most commonly regulates the amount of air and fuel allowed to enter the engine. However, in a gasoline direct injection engine, the throttle regulates only the amount of air allowed to enter the engine. The throttle of a diesel, when present, regulates the air flow into the engine.
Choke valves are important for naturally-aspirated gasoline engines because small droplets of gasoline do not evaporate well within a cold engine. By restricting the flow of air into the throat of the carburetor, the choke valve reduces the pressure inside the throat, which causes a proportionally greater amount of fuel to be pushed from the ...
These types of valves are also known as automatic control valves. The hydraulic actuators respond to changes of pressure or flow and will open/close the valve. Automatic control valves do not require an external power source, meaning that the fluid pressure is enough to open and close them.
For passive heat transfer, a working fluid is a gas or liquid, usually called a coolant or heat transfer fluid, that primarily transfers heat into or out of a region of interest by conduction, convection, and/or forced convection (pumped liquid cooling, air cooling, etc.). The working fluid of a heat engine or heat pump is a gas or liquid ...