Search results
Results from the WOW.Com Content Network
An ASH 31 glider with very high aspect ratio (AR=33.5) and lift-to-drag ratio (L/D=56) In aeronautics, the aspect ratio of a wing is the ratio of its span to its mean chord. It is equal to the square of the wingspan divided by the wing area. Thus, a long, narrow wing has a high aspect ratio, whereas a short, wide wing has a low aspect ratio. [1]
The aspect ratio is the span divided by the mean or average chord. [10] It is a measure of how long and slender the wing appears when seen from above or below. Low aspect ratio: short and stubby wing. Structurally efficient, high instantaneous roll rate, low supersonic drag.
The natural outcome of this requirement is a wing design that is thin and wide, which has a low thickness-to-chord ratio. At lower speeds, undesirable parasitic drag is largely a function of the total surface area, which suggests using a wing with minimum chord, leading to the high aspect ratios seen on light aircraft and regional airliners ...
The ratio of the length (or span) of a rectangular-planform wing to its chord is known as the aspect ratio, an important indicator of the lift-induced drag the wing will create. [7] (For wings with planforms that are not rectangular, the aspect ratio is calculated as the square of the span divided by the wing planform area.)
Trapezoidal planform. In aeronautics, a trapezoidal wing is a straight-edged and tapered wing planform.It may have any aspect ratio and may or may not be swept. [1] [2] [3]The thin, unswept, short-span, low-aspect-ratio trapezoidal configuration offers some advantages for high-speed flight and has been used on a small number of aircraft types.
This tends to increase the lift-induced drag of the foreplane, which may be given a high aspect ratio in order to limit drag. [33] Such a canard airfoil has a greater airfoil camber than the wing. Another possibility is to decrease the aspect ratio of the canard, [34] with again more lift-induced drag and possibly a higher stall angle than the ...
The ratio of the length of a nose cone compared to its base diameter is known as the fineness ratio. This is sometimes also called the aspect ratio, though that term is usually applied to wings and tails. Fineness ratio is often applied to the entire vehicle, considering the overall length and diameter.
For conventional fixed-wing aircraft with moderate aspect ratio and sweep, Oswald efficiency number with wing flaps retracted is typically between 0.7 and 0.85. At supersonic speeds, Oswald efficiency number decreases substantially. For example, at Mach 1.2 Oswald efficiency number is likely to be between 0.3 and 0.5. [1]