Search results
Results from the WOW.Com Content Network
To determine the fracture gradient around the casing shoe and therefore establish the upper limit of the primary well control for the open hole section below the current casing. To investigate well bore capability to withstand pressure below the casing shoe in order to test the well engineering plan regarding the casing shoe setting depth.
As technology has advanced, more modern drillers have better control of the overall well. Oil well control is the management of the dangerous effects caused by the unexpected release of formation fluid, such as natural gas and/or crude oil, upon surface equipment of oil or gas drilling rigs and escaping into the atmosphere.
Well depth values from the wireline loggers operation are referred to as "logger's depth". The loggers depth are typically considered more reliable than the drillers depth. The differences between loggers and drillers depths are due to different stretch in the drilling string when drilling, and the wire line entered into the bore hole during ...
Casing Diameters of a Borehole Casing Diagram premium gas tight connections on a casing string. Casing is a large diameter pipe that is assembled and inserted into a recently drilled section of a borehole. Similar to the bones of a spine protecting the spinal cord, casing is set inside the drilled borehole to protect and support the wellstream.
Driller's depth is always recorded, and it constitutes the primary depth system, unless it is later superseded by a more accurate measurement such as the depth from an open- or cased-hole wireline log. Driller's depth should always have 1) a unit of measurement e.g. meter or feet, 2) a datum reference e.g. rig floor.
CHK – choke (a restriction in a flowline or a system, usually referring to a production choke during a test or the choke in the well control system) CHKSR – checkshot survey report; CHKSS – checkshot survey log; CHOPS – cold heavy oil production with sand; CHP – casing hanger pressure (pressure in an annulus as measured at the casing ...
The tubing may also have flow control mechanism. Single-well concentric kill string: within the well a small diameter concentric kill string is used to circulate kill fluids when needed. Single-well 2-tubing completion: in this instance 2 tubing strings are inserted down 1 well. They are connected at the lower end by a circulating head.
Designing well programs (e.g., casing sizes and setting depths) to prevent blowouts (uncontrolled well-fluid release) while allowing adequate formation evaluation; Designing or contributing to the design of casing strings and cementing plans, directional drilling plans, drilling fluids programs, and drill string and drill bit programs