Ads
related to: safety padlock labeled replacement cover parts breakdown
Search results
Results from the WOW.Com Content Network
A bit key with its main parts labelled. Bitting is the depth of key cuts on a cylinder key for a pin tumbler lock, often expressed as a number. Bitting also refers to the combination of key cuts on a bit key for a warded lock or lever tumbler lock. The exact geometry of modern keys is usually described by a code system. [1]
Two warded lock keys and a homemade skeleton key. A skeleton key (also known as a passkey [1]) is a type of master key in which the serrated edge has been removed in such a way that it can open numerous locks, [2] most commonly the warded lock. The term derives from the fact that the key has been reduced to its essential parts. [2]
Many combination locks have three wheels, but the lock may be equipped with additional wheels, each with a drive pin and fly, in a similar manner. The number of wheels in the mechanism determines the number of specific dial positions that must be entered to open the lock, so a three-sequence combination is required for a three-wheel lock.
Heart locks had two prominent characteristics: one was a spring-loaded cover that pivoted over the keyhole to keep dirt and insects out of the lock that was called a "drop". The other was a point formed at the bottom of the lock so a chain could be attached to the lock body to prevent the lock from getting lost or stolen.
The keyhole of a mechanical cam lock is usually the same as an ordinary padlock. A physical key is used to unlock the lock. The physical key has a notch or slot corresponding to the obstacle in the cam lock, allowing it to rotate freely in the lock. Different from mechanical cam locks, electronic cam locks use an electronic key to unlock.
A Wordlock letter combination lock.. A combination lock is a type of locking device in which a sequence of symbols, usually numbers, is used to open the lock. The sequence may be entered using a single rotating dial which interacts with several discs or cams, by using a set of several rotating discs with inscribed symbols which directly interact with the locking mechanism, or through an ...
A square, rounded or V-shaped depression, filed or machined into a key, to allow the key to turn in its lock. In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin
Lockout Tagout hasp can accommodate up to 6 padlocks, can be used during group LOTO procedure. Lock out, tag out or lockout–tagout (LOTO) is a safety procedure used to ensure that dangerous equipment is properly shut off and not able to be started up again prior to the completion of maintenance or repair work.
Ads
related to: safety padlock labeled replacement cover parts breakdown