Search results
Results from the WOW.Com Content Network
The AWS states that for an equivalent carbon content above 0.40% there is a potential for cracking in the heat-affected zone (HAZ) on flame cut edges and welds. However, structural engineering standards rarely use CE, but rather limit the maximum percentage of certain alloying elements.
The American Welding Society (AWS) publishes over 240 AWS-developed codes, recommended practices and guides which are written in accordance with American National Standards Institute (ANSI) practices. [1] The following is a partial list of the more common publications: [citation needed]
Weldability. The weldability, also known as joinability, [1] of a material refers to its ability to be welded. Many metals and thermoplastics can be welded, but some are easier to weld than others (see Rheological weldability). A material's weldability is used to determine the welding process and to compare the final weld quality to other ...
Welder certification is based on specially designed tests to determine a welder 's skill and ability to deposit sound weld metal. The main part of the welder's test consists of welding one or more test coupons which are then examined using non-destructive and destructive methods. The extent of certification is described by a number of variables ...
Two pointed electrodes apply pressure and current to two or more thin workpieces. Automobile industry, Aerospace industry. Resistance seam welding [6] 22. RSEW. Two wheel-shaped electrodes roll along workpieces, applying pressure and current. Aerospace industry, steel drums, tubing. Projection welding. 23.
The Unified Numbering System for Metals and Alloys (UNS) is an alloy designation system widely accepted in North America. Each UNS number relates to a specific metal or alloy and defines its specific chemical composition, or in some cases a specific mechanical or physical property. A UNS number alone does not constitute a full material ...
Zone II includes most carbon steels with a carbon content above 0.10%. Steels in this zone can be prone to cold cracks. In this case, it is preferable to use low hydrogen filler and slow the cooling rate during welding process. Zone III includes alloy steels with a carbon content above 0.10% and a high carbon equivalent index. Materials in this ...
Hardenability is the depth to which a steel is hardened after putting it through a heat treatment process. It should not be confused with hardness, which is a measure of a sample's resistance to indentation or scratching. [1] It is an important property for welding, since it is inversely proportional to weldability, that is, the ease of welding ...