Search results
Results from the WOW.Com Content Network
British Standard Whitworth. British Standard Whitworth (BSW) is an imperial-unit -based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper.
American wire gauge. American Wire Gauge (AWG) is a logarithmic stepped standardized wire gauge system used since 1857, predominantly in North America, for the diameters of round, solid, nonferrous, electrically conducting wire. Dimensions of the wires are given in ASTM standard B 258. [1] The cross-sectional area of each gauge is an important ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
Clothing sizes are the sizes with which garments sold off-the-shelf are labeled. Sizing systems vary based on the country and the type of garment, such as dresses, tops, skirts, and trousers. There are three approaches: Body dimensions: The label states the range of body measurements for which the product was designed. [1] (.
Body surface area. In physiology and medicine, the body surface area (BSA) is the measured or calculated surface area of a human body. For many clinical purposes, BSA is a better indicator of metabolic mass than body weight because it is less affected by abnormal adipose mass. Nevertheless, there have been several important critiques of the use ...
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.
In 2021, active Formula 1 racing drivers heights range between 1.59 m (5 ft 21⁄2 in) (Tsunoda) and 1.85 m (6 ft 1 in) (Russell and Latifi), with an average of 1.77 m (5 ft 91⁄2 in). [44] As F1 has strict size regulations for cars, designing cars for shorter drivers is easier.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...