Search results
Results from the WOW.Com Content Network
A D-ring used to secure cargo in a utility trailer (A) D-ring (shown in isometric view) (B) Weld-on pivot link; note the incorrect fillet weld call-out (bottom-right). The correct method of securing a weld-on pivot link is a [t weld] which consists of a perpendicular vee butt joint secured to the billet using a butt weld or fusion weld.
The main compartment closes by means of a drawstring secured by a plastic cord clamp. A radio pocket is located against the back on the inside. The size of the pack may be decreased for smaller loads by means of three para-cord ties, stitched to the inside bottom of the pack, and three metal D-rings located directly below the internal radio pocket.
The blades of the rim-driven thruster, by contrast, are mounted on an outer ring rather than a central hub. The ring constitutes the rotor of an electric motor and sits within a surrounding stator, which is also ring-shaped and creates the necessary torque. Rotor and stator are water tight and the whole unit operates submerged.
An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.
Harnesses from the front View of harness from above-rear. A horse harness is a device that connects a horse to a horse-drawn vehicle or another type of load to pull. There are two main designs of horse harness: (1) the breast collar or breaststrap, and (2) the full collar or collar-and-hames.
A Bendix drive is a type of engagement mechanism used in starter motors of internal combustion engines.The device allows the pinion gear of the starter motor to engage or disengage the ring gear (which is attached to the flywheel or flexplate of the engine) automatically when the starter is powered or when the engine fires, respectively.
Like other bearings they permanently rotate between parts, but they are designed to support a predominantly axial load. [1] Thrust bearings come in several varieties. Thrust ball bearings, composed of bearing balls supported in a ring, can be used in low-thrust applications where there is little axial load.
The outdrive resembles the bottom half of an outboard motor and is composed of two sub-units: an upper containing a driveshaft connected through the transom to an engine which transmits power to a 90-degree-angle gearbox; and the lower containing a vertical driveshaft receiving power from the upper unit gearbox, transmitted through another 90 ...