enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.

3. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   7/8"-16 Savage Model 1920 Sq22.86: 2.117 mm 90° Square threads. Also written as 0.900"-12. ... Also written as 0.987"-14. Thread angle varies with production year ...

4. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Unified Miniature Screw Threads: V Thread Form: 0.60 UNM ANSI/ASME B1.11-1958 (R2016) Microscope Objective Thread: V Thread Form ASME B1.13M-2005 (R2015) Metric Screw Threads: M Profile: V Thread Form ASME B1.15-1995 (R2003) Unified Inch Screw Threads (UNJ Thread Form) V Thread Form ASME B1.20.1-2013: Pipe Threads, General Purpose (Inch) Pipe ...

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   Toggle Specifications subsection. ... as well as many British Standard Pipe threads and ISO 7–1, 7–2, ... 14.000 355.6000 16 8 0.12500000 3.1750 1.8120:

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

7. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   The only difference is Komatsu uses millimeter thread sizes while JIS use a BSP (British Standard Pipe) thread. ... Specifications [2] Size Designation Taper width ...

8. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   8.2 20.7: 21.1 3 ⁄ 4: 14: 1.814 1.0410 ... The standard ISO 7 - Pipe threads where pressure-tight joints are made on the threads consists of the following parts:

9. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [ 4 ] Originally parts were made compliant to the specification MIL-F-5509, but they are now controlled under SAE AS (Aerospace Standards) specifications AS4841 through AS4843 and AS4875.