Search results
Results from the WOW.Com Content Network
The engines had only 10 fins for cooling, which caused them to run hot. Another problem was that oil would pool in the cylinder heads, causing it to leak into the valves and burn oil. [3] Another problem was that oil would pool in the crankcase rather than being pumped, causing the engine to overheat and seriously harm performance.
In a wet-sump engine, oil slosh against spinning parts causes substantial viscous drag which creates parasitic power loss. [5] [6] A dry-sump system removes oil from the crankcase, along with the possibility of such viscous drag. More complex dry-sump systems may scavenge oil from other areas where oil may pool, such as in the valvetrain.
In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.
Leak-down testing is a static test. Leak-down tests cylinder leakage paths. Leak-down primarily tests pistons and rings, seated valve sealing, and the head gasket. Leak-down will not show valve timing and movement problems, or piston movement related sealing problems. Any test should include both compression and leak-down.
Kab 101 is a Sea Pony-type minimum-facilities light-production oil platform operated by Mexican state-owned oil company PEMEX, and installed about 26 kilometres (16 mi) off the coast of Tabasco, near the port of Dos Bocas , in 1994. The platform was designed by British engineering firm SLP Engineering Limited. The platform also produces the ...
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
It also eliminated a complex oil jet system to feed the rod bearings in the oil pan. As a side benefit to a prospective purchaser of a used vehicle, this also enabled the condition of the connecting rod and main bearings to be determined indirectly by observation of the oil pressure gauge after the vehicle was warmed up, provided that oil of ...
Another example is the oil pan of an engine. The oil is used to lubricate the engine's moving parts and it pools in a reservoir known as its sump, at the bottom of the engine. Use of a sump requires the engine to be mounted slightly higher to make space for it. Often though, oil in the sump can slosh during hard cornering, starving the oil pump.