Ad
related to: 3.55 axle ratio towing distance for short
Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
Ford used an aluminum matrix composite driveshaft for the 1999–2001 CVPIs as a measure to allow safe operation at high speeds with the 3.55:1 gear ratio, but it was more expensive than the regular aluminum driveshafts and was eliminated with the 3.55:1 rear axle midway through the 2001 model year.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
A 2.73 rear-axle ratio was paired with single-exhaust engines; a numerically higher rear-axle ratio was used as part of the handling package. For 2000 and early 2001, a 3.55 rear axle was used; other versions used a 3.27 rear axle.
The 440+6 and 426 Hemi were available, though this would be the last year for them. The tall axle ratios with the 8 3/4-inch Chrysler and Dana 60 rear ends, as well as the wide and close-ratio 4-speed transmissions, could be had with any of the engine choices, though few cars were built with the six-pack or Hemi engines. Aerodynamics were much ...
Distance between the centerline of the mainshaft and the countershaft is 85mm. [1] [5] Fully synchronized forward and reverse gears. A two piece aluminum housing with no access plates. A shift tower mounted shift lever. GM RPO codes; Wide-ratio MG5; Close-ratio M50; Dodge order code DDC; The Medium duty version is rated for 300 ft-lbf of torque
The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length. The TTB axles are variations of the Dana 28, Dana 35 , Dana 44 , and Dana 50 .
Ad
related to: 3.55 axle ratio towing distance for short