Search results
Results from the WOW.Com Content Network
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...
The serial number of this pistol is located under the dust cover on the frame, on the barrel, and on the slide. The bolt of an Arisaka military rifle, which carries identifiers matching the main serial number which is on the receiver. A gun serial number is a unique identifier assigned to a singular firearm. [A]
The serial number follows the aircraft throughout its period of service. In 2009, the U.S. FDA published draft guidance for the pharmaceutical industry to use serial numbers on prescription drug packages. [2] This measure is intended to enhance the traceability of drugs and to help prevent counterfeiting.
cmd.exe in Windows NT 2000, 4DOS, 4OS2, 4NT, and a number of third-party solutions allow direct entry of environment variables from the command prompt. From at least Windows 2000, the set command allows for the evaluation of strings into variables, thus providing inter alia a means of performing integer arithmetic.
The nearest power-of-2 integer that is not smaller than this value is the number of unique initial APIC IDs reserved for addressing different logical processors in a physical package. [a] Former use: Number of logical processors per physical processor; two for the Pentium 4 processor with Hyper-Threading Technology. [47]
The command syntax shows some characters in a mixture of upper and lower case. Abbreviating the command to only sending the upper case has the same meaning as sending the upper and lower case command. [3] For example, the command “SYSTem:COMMunicate:SERial:BAUD 2400” would set an RS-232 serial communications interface to 2400 bit/s.
Add the digits (up to but not including the check digit) in the even-numbered positions (second, fourth, sixth, etc.) to the result. Take the remainder of the result divided by 10 (i.e. the modulo 10 operation). If the remainder is equal to 0 then use 0 as the check digit, and if not 0 subtract the remainder from 10 to derive the check digit.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...