Search results
Results from the WOW.Com Content Network
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
In VLSI devices, the power-on reset (PoR) is an electronic device incorporated into the integrated circuit that detects the power applied to the chip and generates a reset impulse that goes to the entire circuit placing it into a known state.
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
Since ATX power supplies share both the same dimensions (150 × 86 mm (5.9 × 3.4 in)) and the same mounting layout (four screws arranged on the back side of the unit), with the prior format, there is no major physical difference preventing an AT case from accepting an ATX PSU (or vice versa, if the case can host the power switch needed by an ...
Power cycling is the act of turning a piece of equipment, usually a computer, off and then on again.Reasons for power cycling include having an electronic device reinitialize its set of configuration parameters or recover from an unresponsive state of its mission critical functionality, such as in a crash or hang situation.
A simple general-purpose desktop power supply used in electronic labs, with power output connector seen at lower-left and power input connector (not shown) located at the rear Interior of high-end linear power supply with toroidal mains transformer.
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized.
The connector first appeared in the Nvidia RTX 40 GPUs. [5] [6] The prior Nvidia RTX 30 series introduced a similar, proprietary connector in the "Founder's Edition" cards, which also uses an arrangement of twelve pins for power, but did not have the sense pins, except for the connector on the founders edition RTX 3090 Ti (though not present on the adapter supplied with those cards.) [7]