Search results
Results from the WOW.Com Content Network
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification. It is primarily a means of testing the communications infrastructure. Loopback can take the form of communication channels with only one communication endpoint.
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM).This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs).
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer. Ethernet Configuration Testing Protocol was implemented on DEC hosts and Cisco routers. [2]
Private network Used for local communications within a private network [3] 198.18.0.0/15 198.18.0.0–198.19.255.255 131 072: Private network Used for benchmark testing of inter-network communications between two separate subnets [9] 198.51.100.0/24 198.51.100.0–198.51.100.255 256: Documentation Assigned as TEST-NET-2, documentation and ...
One such example is its use in data center bridging requirements. The Data Center Bridging Capabilities Exchange Protocol (DCBX) is a discovery and capability exchange protocol that is used for conveying capabilities and configuration of the above features between neighbors to ensure consistent configuration across the network. [3]
A LAG is a method of inverse multiplexing over multiple Ethernet links, thereby increasing bandwidth and providing redundancy. It is defined by the IEEE 802.1AX-2008 standard, which states, "Link Aggregation allows one or more links to be aggregated together to form a Link Aggregation Group, such that a MAC client can treat the Link Aggregation Group as if it were a single link."
In a very simple example, a switch with three ports A, B, and C has a normal node connected to port A while ports B and C are connected to each other in a loop. All ports have the same link speed and run in full duplex mode. Now, when a broadcast frame enters the switch through port A, this frame is forwarded to all ports but the source port, i ...
IPv4 network standards reserve the entire address block 127.0.0.0 / 8 (more than 16 million addresses) for loopback purposes. [2] That means any packet sent to any of those addresses is looped back. The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems.