Ad
related to: edenpure heaters 750 psi electric gas generator manual instructions
Search results
Results from the WOW.Com Content Network
The last portion of the generator with which the gases come into contact remains the cold incoming water. The fire is positively cut off when the pressure reaches a pre-determined point, usually set at 750 psi (5.2 MPa), cold water pressure; a safety valve set at 1,200 lb (544 kg) provides added protection. The fire is automatically cut off by ...
A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream, such as a combustion turbine or other waste gas stream. It produces steam that can be used in a process ( cogeneration ) or used to drive a steam turbine ( combined cycle ).
A supercritical steam generator is a type of boiler that operates at supercritical pressure and temperature, frequently used in the production of electric power. In contrast to a subcritical boiler in which steam bubbles form, a supercritical steam generator operates above the critical pressure – 22 megapascals (3,200 psi ) and temperature ...
An electric heater is an electrical device that converts an electric current into heat. [1] The heating element inside every electric heater is an electrical resistor , and works on the principle of Joule heating : an electric current passing through a resistor will convert that electrical energy into heat energy.
From cars the main source of energy is the exhaust gas. [32] Harvesting that heat energy using a thermoelectric generator can increase the fuel efficiency of the car. Thermoelectric generators have been investigated to replace the alternators in cars demonstrating a 3.45% reduction in fuel consumption. [33]
Finally properties such as small surface density and counter-flow arrangement of regenerators make it ideal for gas-gas heat exchange applications requiring effectiveness exceeding 85%. The heat transfer coefficient is much lower for gases than for liquids, thus the enormous surface area in a regenerator greatly increases heat transfer.
The hot exhaust gas from an MHD generator can heat the boilers of a steam power plant, increasing overall efficiency. Practical MHD generators have been developed for fossil fuels, but these were overtaken by less expensive combined cycles in which the exhaust of a gas turbine or molten carbonate fuel cell heats steam to power a steam turbine.
In commercial power plants, there are two to four steam generators per reactor; each steam generator can measure up to 70 feet (21 m) in height and weigh as much as 800 tons. Each steam generator can contain anywhere from 3,000 to 16,000 tubes, each about .75 inches (19 mm) in diameter.
Ad
related to: edenpure heaters 750 psi electric gas generator manual instructions