Search results
Results from the WOW.Com Content Network
Porsche started using Nikasil on the 1970 917 race car, and later on the 1973 911 RS. Porsche also used it on production cars, but for a short time switched to Alusil due to cost savings for their base 911. Nikasil cylinders were always used for the 911 Turbo and RS models.
The HR13DDT is a 1.3 L (1,332 cc) all-aluminium direct injected and turbocharged straight-four engine equipped with lifetime timing chain, 16v DOHC, VVT, variable displacement oil pump, Stop-Start, regenerative braking, and Bore Spray Coating system (as installed in Nissan GT-R models), Bore: 72.2 mm (2.84 in), Stroke 81.3 mm (3.20 in). There ...
The XN was a family of inline-four petrol engines closely related to the smaller XM-series, used mainly in the Peugeot 504 and 505 family cars but in certain other vehicles as well. These engines have an OHV design valvetrain, with two valves per cylinder. Bore and stroke are 88 mm and 81 mm, respectively.: XN1 — 2.0 L (1,971 cc). Carburetor ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
Alusil as a hypereutectic aluminium-silicon alloy (EN AC-AlSi17Cu4Mg / EN AC-48100 or A390) contains approximately 78% aluminium and 17% silicon. [1] [2] This alloy was theoretically conceived in 1927 by Schweizer & Fehrenbach, [3] of Badener Metall-Waren-Fabrik, [4] but practically created only by Lancia [5] in the same year, for its car engines.
Car finance comprises the different financial products which allows someone to acquire a car with any arrangement other than a single lump payment. When used, and for the purpose of assessing the private financial costs, one must consider only the interests paid by the car owner, as some part of the amount the owner pays each month for the finance is already embedded in the depreciations costs.
This engine replaced the 250 cu in (4.1 L) straight-six in full-size Chevrolets and Camaros as the base six-cylinder engine. Additionally, the intermediate Chevrolet Malibu and Monte Carlo also used the 229 cu in (3.8 L) as a replacement for both the 200 cu in (3.3 L) V6 and the 231 cu in (3.8 L) Buick V6 .
Bore and stroke size is 3.552 in × 4.165 in (90.2 mm × 105.8 mm), identical to the 5.4 L V8. Both 2-valve and 3-valve versions have been produced. The 6.8 L uses a split-pin crank with 72° firing intervals and a balance shaft gear driven by the left camshaft to quell vibrations inherent to a 90° bank angle V10 engine.