Search results
Results from the WOW.Com Content Network
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.
The fittings come in a variety of configurations, such as tee-pieces, straight couplers, elbows or bends, reducers (to join pipes of different diameters), stop-ends, and there are versions with screw threads (male or female) at one end to fit taps and iron pipes. Valves such as stoptaps & gate valves are also available in solder ring configuration.
These standard pipe threads are formally referred to by the following sequence of blocks: the words, Pipe thread, the document number of the standard (e.g., ISO 7 or EN 10226) the symbol for the pipe thread type: G, external and internal parallel (ISO 228) R, external taper (ISO 7) Rp, internal parallel (ISO 7/1) Rc, internal taper (ISO 7)
Alternatively it is a short length of pipe with two female National pipe threads (NPT) (in North American terms, a coupler is a double female while a nipple is double male) or two male or female British standard pipe threads. If the two ends of a coupling are of different standards or joining methods, the coupling is called an adapter. Examples ...
Copper and its alloys, mild steel, and in some cases small diameter stainless steel pipes are most commonly reamed with hand tools. [ 15 ] Copper is perfectly machinable, a quality tool successfully performs wall deformation, the surface remains smooth, the wall thickness is almost the same, and the material retains a homogeneous structure.
The seal provided by a threaded pipe joint is created when a tapered externally threaded end is tightened into an end with internal threads. For most pipe joints, a good seal requires the application of a separate sealant into the joint, such as thread seal tape , or a liquid or paste pipe sealant such as pipe dope .