enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    Washers of standard metric sizes equivalent to BS4320 Form A are listed in the table below. Measurements in the table refer to the dimensions of the washers as described by the drawing. Specifications for standard metric flat washers were known as DIN 125 (withdrawn) and replaced with ISO 7089.

  3. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  4. List of metric units - Wikipedia

    en.wikipedia.org/wiki/List_of_metric_units

    The first group of metric units are those that are at present defined as units within the International System of Units (SI). In its most restrictive interpretation, this is what may be meant when the term metric unit is used. The unit one (1) is the unit of a quantity of dimension one. It is the neutral element of any system of units. [2]

  5. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size table. Unified Screw Threads Series; ASME B1.1-2003 Unified Inch Screw Threads, (UN and UNR Thread Form)

  6. ISO 898 - Wikipedia

    en.wikipedia.org/wiki/ISO_898

    ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners. This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1.

  7. United States Standard thread - Wikipedia

    en.wikipedia.org/wiki/United_States_Standard_thread

    The thread form is defined by flats at the tip and root of the thread form. This flat length is defined as the pitch divided by eight. The thread depth, which is from flat to flat is 0.6495 times the pitch. [4] For 1 ⁄ 4-inch (6.4 mm) screws and larger, the pitch is defined as: = +

  8. System of units of measurement - Wikipedia

    en.wikipedia.org/wiki/System_of_units_of_measurement

    Traditional Burmese units of measurement are used in Burma, with partial transition to the metric system. U.S. units are used in limited contexts in Canada due to the large volume of trade with the U.S. There is also considerable use of imperial weights and measures, despite de jure Canadian conversion to metric.

  9. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Nut Threads from 8 to 100 mm Nominal Diameter: Active: DIN 103-6: ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Nut Threads from 105 to 300 mm Nominal Diameter: Active: DIN 103-7: ISO Metric Trapezoidal Screw Threads; Limiting Sizes for Bolt Threads from 8 to 100 mm Nominal ...